SIEMENS 6SE7014-0TP50-0TP60 SIMOVERT Control Inverter Unit

6SE7014-0TP50-0TP60 SIEMENS

New in stock     

Origin from Germany

Payment Method: TT.Western Union

Shipping Method: DHL\UPS\Fedex\EMS\Others 

Specification

Trade Process

Frequent Questions and Answers

1. What do the 005 display state or parameter setting issues mean?

• Cause: The 005 state often appears if parameter P060 is set to 5 (Drive Setting mode), or accidentally after a factory default reset.

• Solution:

• Check and adjust P060. Returning to normal operation typically requires setting P060 = 7.

• Warning: If the drive has been factory-defaulted, you must run through hardware setting mode (P060 = 8) and configure parameter P070 with the correct hardware number before running, otherwise permanent damage can occur.

2. How do you restore factory settings on this drive?

• Procedure: Typically done via the parameter menu or OP1S/PMU operator panel using a sequence such as setting P053 = 6, P060 = 2, and P970 = 0 (refer to the official compendium for your exact software version).

3. What should I check if the drive trips, fails, or burns out?

• Common Causes:

• Short circuits / Debris: Conductive metal dust or particles falling into the top/interior of IP20 chassis units.

• Phase loss: Missing input supply phases or unstable line voltage.

• Capacitor and DC link hazards: Even after disconnecting the main AC voltage supply, internal DC-link capacitors stay energized for a dangerous period. Always wait and verify zero voltage before touching terminals.